INOXPAN S.L. EN - 10
5.1. MANUAL OPERATION
After setting the clock, the oven is ready for use. Select a cooking function and temperature.
You will notice that the symbol lights up during cooking to indicate that heat is being
transmitted to the food..
This symbol disappears when the selected temperature has been reached.
Set the controls to to turn off the oven.
5.2. OVEN TIMER OPERATION
PROGRAMMING THE BUZZER
1. 1. Touch or until the symbol on the display starts flashing, then press . The indication
‘00:00’ will appear on the display
2. 2. Select the time after which you want the alarm to sound by pressing or . You will hear
2 beeps to confirm that the time has been set and the clock will start counting down from the
selected time. The symbol will flash slowly.
3. 3. Once the time has expired, an acoustic signal will sound for 90 seconds and the
symbol
will flash quickly.
4. Touch any key to stop the alarm. The symbol will then disappear.
If you wish to modify the time on the buzzer, repeat the steps shown. Upon entering the timer control,
the time currently remaining will appear, which you will be able to adjust.
In models with an electronic temperature control, when the selector switch is turned, the clock
display will show the temperature.
After selecting the temperature, the clock display will automatically reappear.
To see the temperature again during cooking, press the button
and turn the temperature dial
if you want to change it.
When you start cooking, your oven will show the time the oven has been cooking.
With the Buzzer function, the oven will not turn off when the time expires.
With the Buzzer function, the remaining time will show permanently on the display. With this
programmed function, it is not possible to view the time or the total programmed cooking time.
To Next Page
Loading...
