How to troubleshoot a Pando Oven that suddenly stops working?
If your Pando Oven stops working, first check the power connection. Then, inspect the fuses and circuit breaker of your home's electrical installation. Also, ensure the timer is set to either manual or programmed mode, and verify the control and temperature dials are correctly positioned.
Why is my Pando Oven smoking during use?
It's normal for a Pando Oven to smoke during its first use. However, if smoking persists, clean the oven regularly. Reduce the amount of fat or oil used on the tray, and ensure you're not cooking at temperatures exceeding those recommended in the cooking chart.
How to fix the inside light of my Pando PHT-941 if it doesn't turn on?
If the inside light of your Pando Oven isn't working, try changing the bulb. Also, check that the bulb has been properly installed according to the Installation Instructions.
What to do if the Pando PHT-941 Oven is on but the door won't open?
If your Pando Oven is on, the symbol is lit, but the door won't open, the door lock might be activated. Turn the control dial to the correct position. You may need to deactivate the door lock following the instructions in the User’s guide. To continue cooking, re-select the desired cooking function.
Why doesn't the heating pilot light turn on in my Pando PHT-941?
If the heating pilot light on your Pando Oven does not turn on, make sure you have selected a temperature and a cooking setting. Note that the pilot light should only illuminate while the oven is actively heating to the selected temperature.
What to do if the Pando PHT-941 door won't open and the symbol is lit?
If your Pando Oven is off, the symbol is lit, and the door won't open, the door lock is likely activated. Deactivate the door lock following the instructions in the User’s guide.
Why are the cooking results not achieved with my Pando PHT-941?
If you are not achieving the expected cooking results with your Pando Oven, check the cooking charts for guidance on how your oven operates.
What does it mean if the symbol flashes quickly and a buzzer sounds on my Pando PHT-941 during pyrolysis?
If you've selected a pyrolysis program on your Pando Oven and the symbol flashes with a buzzer, the oven door isn't properly closed. Ensure the door is fully closed, set the control dial to the correct position, and repeat the sequence to start pyrolysis.
Why is the door still locked on my Pando PHT-941 even when the control dial is in the correct position?
If the control dial of your Pando Oven is in the correct position and the door remains locked, the oven hasn't cooled down to a safe temperature. Wait until the oven cools and the symbol turns off.
Why are my Pando PHT-941's accessories and shelf supports damaged?
If the accessories and shelf supports of your Pando Oven are damaged, you likely didn't remove them during the pyrolytic cleaning cycle. You must replace the damaged parts and remember to remove them before future cleaning cycles.
To Next Page
General
