Step 3. Dishwasher installation steps
1. Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into .
6. Level the dishwasher. The rear foot can be adjusted from the front of the
dishwasher by turning the in the middle of the base of dishwasher
use . To adjust the front feet, use a flat screw driver and turn the
front feet until the dishwasher is level. (Step 5 to Step 6)
7. Install the furniture door to the outer door of the dishwasher. (Step 7 to Step 9)
8. The dishwasher must be secured in place. There are two ways to do this:
A. Normal work surface: Put the installation hook into the slot of the side plane and
secure it to the work surface with
B. Marble or granite work top: Fix the side with .
the cabinet
a driver
the screws.
screws
Philips screw
Philips screw
Please refer to the specific installation steps in the installation
drawings.
Please refer to the installation steps in the installation
drawings.
specific
A
B
51
To Next Page
Loading...
