AUTONOMOUS TRACKER PANDORA FINDER USER MANUAL
18 19
The tracker will answer - “PIN-code changed” after the command
execution.
XXXX*666* - Switching on the “Tracking mode”. The tracker will
activate the “Tracking mode” for a previously specied period or until a
command to switch it o would be received.
The tracker will answer - “Settings changed” after the command
execution.
ХХХХ*999* - Switching o the “Tracking mode”.
ХХХХ*ALARM*YYY* - Setting periodicity of communication.
YYY – hours value from 001 to 168.
The tracker will answer - “Settings changed” after the command
execution.
ХХХХ*500* - Request current location.
ХХХХ*100* - Request balance of the SIM-card.
ХХХХ*007* - Switching on the “Listening” function.
WARNING! MOST MOBILE PROVIDERS STORE UNDELIVERE
MESSAGES NO MORE THAN 24 HOURS.
REPLACING OR RECHARGING THE BATTARIES
When replacing or recharging the batteries, it is necessary to carefully
perform the following sequence of actions:
• Open the cover of the device;
• Replace the batteries;
• Insert the batteries keeping in mind the correct polarity.
• Close the cover;
• Activate the tracker in an open area with ne GPS signal.
WARNING! IT IS PROHIBITED TO RECHARGE THE BATTERIES
THAT ARE INCLUDED IN THE SYSTEM SET. IT IS RECOMMEND-
ED TO USE LITHIUM (LI-FES2) BATARIES ESPECIALY AT LOW
TEMPERATURES. ALKALINE BATARIES ARE ALSO ALLOWED;
DO NOT USE REGULAR ZINC-CARBON BATTERIES.
TRACKER INSTALLATION
The following conditions must be considered when installing the tracker:
• Good conditions for signals of the GPS/GLONASS receiver, GSM
modem, 2.4GHz radio interface (BLE4.2);
• Good conditions for the built-in microphone operation;
• The module must be rigidly xed in order to avoid damage and
movement while driving;
• The device must be installed in places where there are no any
liquids, condensate and high temperature;
• The module should be installed the front side up (the side with the
Pandora sign, the VALET button and the LED).
To Next Page
Loading...
Need help?
General
