AUTONOMOUS TRACKER PANDORA FINDER USER MANUAL
16 17
- Turn on the Bluetooth on your phone and run the Pandora NAV BT app;
- Press and hold the VALET button for 3 seconds (3 ashes of the LED),
release the button after the third ash – the tracker will activate the
Bluetooth connection;
- Select the found device in the «Search» menu of the application,
enter the pairing PIN-code 0-0-0-0-0-0, the devices will be paired after
conrming the PIN-code entry.
NOTE! TO rE-pair ThE mObilE dEvicE wiTh ThE TrackEr, iT is
rEquirEd TO rEmOvE ThE bluETOOTh cONNEcTiON frOm ThE mObilE
phONE aNd frOm ThE TrackEr.
• To remove a mobile device from the tracker memory:
- Press and hold the VALET button for 6 seconds (until a 6 ash of the
LED), release the button after the 6th ash – the tracker will remove the
previously paired device;
- Then the tracker will activate pairing mode for 1 minute.
Using the app
Being in the Bluetooth radio coverage zone, Press and hold the VALET
button for 3 seconds (3 ashes of the LED), run the PANDORA NAV BT
application. The application will automatically detect the system and
make a connection. The main menu will be opened after making the
connection.
FIRMWARE UPDATE
In order to update the tracker rmware, press and hold the VALET
button form more than 10 seconds until smooth icker appears.. Run
the PANDORA NAV BT, go to «Search device» and select the found
device.
You can select one of the update options
• internet - you can upload the latest rmware from the internet
server.;
• File manager (Only for Android)- you can upload the rmware from
the phone’s memory. (the rmware is available on pandorainfo.com).
CONTROL USING SMS COMMANDS
The tracker can receive and execute SMS commands. The tracker
receives SMS messages when it wakes up. To protect the tracker against
unauthorized messages each command must contain the Service PIN-
code - ХХХХ (factory default value is 1-1-1-1).
WARNING! WE RECOMMEND THAT YOU CHANGE THE DE-
FAULT VALUE OF THE SERVICE PIN-CODE
ХХХХ*PIN*YYYY* - Changing the “Service PIN-code”. This command
can be executed only from the phone number that has been previously
programmed in the tracker memory
ХХХХ – current PIN-code (default value is 1-1-1-1)
YYYY – new PIN-code.
To Next Page
Loading...
Need help?
General
