Last update: 2020/06/11 19:20 hardware:fb4:quickstart https://wiki.pangolin.com/doku.php?id=hardware:fb4:quickstart
https://wiki.pangolin.com/ Printed on 2021/03/13 07:17
The “Scan Guard” feature should only be turned on when the feedback signals from the scanner
amplifier are connected to FB4.
If you are not getting any light out, please verify “Scan Guard” is turned off in the user interface.
Downloads
FB4 Quickstart guide
From:
https://wiki.pangolin.com/ - Pangolin Wiki
Permanent link:
https://wiki.pangolin.com/doku.php?id=hardware:fb4:quickstart
Last update: 2020/06/11 19:20
To Previous Page
Loading...
