2021/03/13 07:17 7/8 FB4 QuickStart Guide
Pangolin Wiki - https://wiki.pangolin.com/
Red LED (Emission status)
Legend
Troubleshooting
Laser Show Designer Quickshow or Beyond is not connecting to my laser
Verify that FB4 is properly connected to the network and has acquired an IP address. Under
“Network settings” in the user interface, try turning on AutoIP.
One or more colors is not turning on
Check under “Color” settings in the user interface and make sure all the color channels are turned
to 100%.
I hear the scanners running, but there is no light coming out of the laser projector
To Next Page
Loading...
