Pantech P4100 - Connecting to a 3 G Network

Setting Wi-Fi networks
1. Tap Settings from the applications menu.
2. Tap Wireless & networks > Wi-Fi settings.
3. Tap Wi-Fi to activate the technology.
4. Tap Automatic connection if you want the P4100 to connect to the Wi-Fi network
automatically.
5. Tap WPS connection and tap Button connection or PIN connection if you want to
establish a new wireless connection using the Wi-Fi Protected Setup (WPS). You should
press WPS button or enter PIN on your Wi-Fi access point within two minutes.
Searching for Wi-Fi networks
1. Tap Settings from the applications menu.
2. Tap Wireless & networks > Wi-Fi settings.
3. Tap Wi-Fi to activate the technology. The P4100 scans networks automatically every six
seconds. The newly found networks appear on the bottom of the list.
Adding a Wi-Fi network
1. Tap Settings from the applications menu.
2. Tap Wireless & networks > Wi-Fi settings.
3. Tap Wi-Fi to activate the technology.
4. Tap Add Wi-Fi network.
5. Enter Network SSID and select the security type among Open, WEP, WPA/WPA2 PSK and
802.1x EAP. Aside from Open, you must enter a password for the network.
6. Tap Save.
Disconnecting to a Wi-Fi network
1. Tap the network that is connected to the P4100.
2. Tap Forget to disconnect with the network.
Connecting to a 3G network
Use 3G (or EDGE if available) to connect the P4100 to the Internet. You will need a data plan to