Panther 1650 - Page 8

PANTHER
MODEL PAGE NO.
1350 / 1650 6
SECTION – 1
INTRODUCTION
1.1 Machine specifications.
Descriptions
MODEL
1350/1 1350/2 1650/1 1650/2
Type of bed.
Gap bed Gap bed Gap bed Gap bed
Length of bed.
1370 mm 1830 mm 1830 mm 2440 mm
Width of bed.
230 mm 230 mm 265 mm 265 mm
Height of centre.
177 mm 177 mm 215 mm 215 mm
Admit between
centers.
540 mm 1000 mm 1000 mm 1500 mm
Swing over bed.
335 mm 335 mm 410 mm 410 mm
Swing over saddle.
245 mm 245 mm 310 mm 310 mm
Swing over cross slide.
200 mm 200 mm 250 mm 250 mm
Swing in gap.
535 mm 535 mm 610 mm 610 mm
Length of gap in front
of faceplate.
125 mm 125 mm 125 mm 125 mm
No. of spindle speed.
8/16 8/16 8/16 8/16
Spindle speed range.
45-938/30-
1250
45-938/30-
1250
45-938/30-
1250
45-938/30-
1250
Taper in spindle.
MT 4 MT 4 MT 4 MT 4
Spindle hollow.
42 mm 42 mm 42 mm 42 mm
Spindle nose detail.
A2 size 4 or A2 size 4 or A2 size 4 or A2 size 4 or
D1 size 4 D1 size 4 D1 size 4 D1 size 4
No. of British threads.
65 65 65 65
Range of British
threads.
4-60 TPI 4-60 TPI 4-60 TPI 4-60 TPI
No. of Metric threads.
54 54 54 54
Range of Metric
threads.
0.35-6 mm 0.35-6 mm 0.35-6 mm 0.35-6 mm
No. of D.P. threads.
44 44 44 44
Range of D.P. threads.
8-140 DP 8-140 DP 8-140 DP 8-140 DP