Pantum P2207 User Manual

5. Click “Agree” on the prompt window popping out to accept the licensing agreement.
6. Click “Install”.
7. Input computer password and click “Install Software”.
8. Click “Continue Installation” on the prompt window popping out.
9. The system will finish driver installation automaticall .
• If using a USB cable to connect a computer with a Wi-Fi model printer, a wireless network
configuration prompt window will pop up during driver installation, as shown in following
picture.
Note: • click “Yes”, you can configure printer’s wireless network via wireless network
configuration tool (refer to Chapter 5.1.1 for how to make configuration).When
configuration is completed, unplug USB cable, and then on the pop-up “Add
Printer” interface, you may add the network-connected printer(refer to Chapter 3.3
for how to add printer).
• Click “No”, you can add a USB-connected printer on the pop-up “Add Printer”
interface (refer to Chapter 3.3 for how to add printer).
If using a USB cable to connect a computer with a non-Wi-Fi model printer, a “Add Printer”
interface will pop up during the driver installation and you can add a printer here (refer to
Chapter 3.3 for how to add printer).
3-24

Pantum P2207 Specifications

General

Print Technology	Monochrome Laser
Print Resolution	1200 x 1200 dpi
Processor Speed	600 MHz
Memory	128 MB
Connectivity	USB 2.0
Input Capacity	150 sheets
Output Capacity	100 sheets
Duplex Printing	Manual
Compatible Operating Systems	Windows, Mac OS, Linux
Print Speed	22 ppm
Media Sizes Supported	A4, Letter, Legal, Executive, Oficio, Envelope (C5, DL, Monarch)
Media Types Supported	Plain, Thick, Thin, Cardstock, Label, Envelope
Weight	4.75 kg
Dimensions	337 x 220 x 178 mm
First Print Out Time	Less than 7.8 seconds