9.1.5.Restore Factory Settings
“Recover factor settings” is used to recover the default settings of printer.
The printer will restart itself automatically after recovering factory settings.
1) Press "Menu" to enter the Menu Settings interface.
2) Press "OK" to select the "1.System Setting" option.
3) Press direction key "▲" or "▼" to select the "5.Restore Set" option and press "OK".
Note：
• Factory settings of network printer can be recovered via embedded
Web server (please refer to Chapter 6.2.3.3).
• As for printers with LED control panel, press the power key to turn printer
on and then press the Cancel/Continue key for more than 2s untilthe two green
status lights on the panel start to blink at the same time. Then, release the key
and wait for factory settings of the printer to recover. The printer will restart itself
automatically after finishing recovering factory settings.
9.1.6.Print a Page for Clean & Fix
1) Press "Menu" to enter the Menu Settings interface.
2) Press "OK" to select the "1.System Setting" option.
3) Press “▲”or“▼”and select "Clean & Fix" option, then press "OK" to start cleaning and fixing
of the fuser unit.
"Print a Page for Clean & Fix"function can clean the toner, paper powder and other inpurities,
so as to realize better printing effect.The printer will start up Print a Page for Clean & Fix
function automatically after the printer has printed a certain number of pages. You can also
launch Print a Page for Clean & Fix function manually by setting up the printer panel. The steps
are as follows:
Note：
• For printers having LED control panels, double click "Cancel/Continue" button on
the panel to start up cleaning and fixing of the fuser unit.
To Next Page
Loading...
Need help?
General
