cod.?7&45
" apillon·
blade re-sharpened
or
replaced by a customer service centre (measurement
of
imbalance).
Unbalanced blades will
cause the brushcutter to vibrate violently-risk
of
accident!
Change
and
clean
the
spark
plug
1)
Once the engine has cooled, remove the spark plug using the socket spanner.
2)
Clean the plug with a wire brush.
3)
Using a feeler gauge;
set
the
gap
to
0.6-0.7 mm.
4) Install the spark plug carefully by hand, to avoid cross-threading.
5) After the
spark plug Is In place, Ughten with spanner
to
compress the washer.
Clean
the
air
filter
Unclip
the
air
filter cover and remove the sponge filter element.
To
avoid objects falling into the air
tank,
replace the
air
fitter cover. Wash the filter element
in
warm
soap water, rinse and allow
it
to dry
naturally.
Wamlngl
Never run the engine without the air filter element installed.
Storing
the
unit
After cutting, clean the unit thoroughly. Store the unit in a dry room, allow the motor to cool down
beforehand.
Troublnhooting
Before
perfonning
any
maintenance
or
cleaning
work,
always
turn
off
the
engine
and
wait
until
the
cutter
has
come
to
a
standstill
1)
Engine
does
not
run:
--Reassemble the blade
or
Nylon cutter.
--check
the fuel level.
2) Engine
power
drops:
--Have
cutting blade re-sharpened /replaced (customer service centre)
3)
If
the
temperature
af
machines
Is
too
high:
--insure
the machines have rest
at
regular time.
Faulta which cannot be rectified with
the
aid
of
this table may be rectified by a specialist company
only (customer service centre).
40
To Next Page
Loading...
