Paradigm PW 300 - Features and Functions; Power Button Controls; Reboot and Reset Procedures; Volume Adjustment

FEATURES & FUNCTIONS
Power Button ( ):
• Press
to power on/off.
- If no signal is received for 20
minutes, unit will enter into standby.
- Power & Bluetooth LED will turn off;
Wi-Fi indicator will remain illuminated
(unless connected via Ethernet).
Power Button ( ) (Reboot & Reset):
Reboot:
• Press & hold for 3 sec to clear
currently connected Bluetooth Devices.
- Power button LED will blink once
indicating pairing has been broken.
- Tone will verify a cleared unit.
- Bluetooth indicator will return to
discovery mode.
Reset:
• Press & hold for 10 sec to reset your
PW 300 to factory settings (Reset).
- Note this will clear all current
networks and Bluetooth devices.
- Power button will begin to blink after
10 sec, followed by the Bluetooth and
Wi-Fi Indicator.
- Tone will verify reset is complete.
Volume Up/Down Buttons (
/ ):
• Press
to increase the volume level.
• Press to decrease the volume level.
• Press and hold either
/ to ramp the
volume level up or down.
Wi-Fi Indicator (
):
The Wi-Fi Indicator ( ) tells you what your
PW 300 is doing:
• Fast Blinking — Your PW 300 is booting up.
• Blinking — Your PW 300 is attempting to
connect to a wireless router.
• Slow Pulse — Setup Mode.
• Two Blinks > Pause — WPS Mode.
• Solid White — Connected to router.
• Off — Connected to a router
using a wired connection.
Bluetooth Indicator (
):
The Bluetooth Indicator ( ) tells you
what your Paradigm product is doing:
• Blinking — Discovery Mode.
• Solid Blue — Connected
to Bluetooth Device.
• Solid Green — Connected to
Play-Fi Device (Play-Fi In Use).
• Off — Unit In Standby Mode.
Wi-Fi Setup Button:
Initiates Wi-Fi setup for both Wi-Fi
Protected Setup (WPS) and Standard
Wi-Fi Setup.
• Push & hold for 4 seconds to enter
WPS setup mode.
• Push & hold for 8 seconds to reset
all wireless settings.
• Places your PW 300 into setup mode
(Slow Pulse Wi-Fi Indicator).
6