User Quick Reference Guide (1686V & 1686H)
KEYPAD OVERVIEW
1686V LED Keypad
REGULAR: Arms entire partition when all
zones are closed.
Enter your [
ACCESS CODE]* (or press and
hold the [
ENTER]
†
key for 3 seconds).
FORCE: Arms entire partition without waiting
for all zones to close.
Press the [FORCE] key, and then enter your
[
ACCESS CODE]* (or press and hold the
[
FORCE]
†
key for 3 seconds).
S
TAY
:
Arms partition’s perimeter only, which
allows you to remain in the protected area.
Press the [STAY] key, and then enter your
[
ACCESS CODE]* (or press and hold the
[
STAY]
†
key for 3 seconds).
INSTANT: Stay arms partition, but an alarm
will occur instantly if a zone opens, including
entry delay zones.
After Stay arming, press and hold the
[
STAY]
†
key for 3 seconds.
*If keys [1] and [2] flash, you must specify which partition you wish to arm or disarm by pressing the
corresponding key.
†
Must be enabled by your installer.
HOW TO ARM AND DISARM
Disarming
Enter your [ACCESS CODE]*.
AC LIGHT
On = AC power on
Off = Power failure
READY LIGHT
On = All zones are closed
Off = Zone(s) open or armed
Flash = Exit Delay indicates
that the system will become
armed soon
ARM LIGHTS
On = Partition armed
Off = Partition disarmed
Flash = Partition Stay armed
Fast Flash = Partition in
alarm
Press and hold the [PG] key for 3
seconds to activate:
__________________________
(i.e. garage door, smoke reset, etc.)
Made a mistake?
Press the [
CLEAR] key to re-enter
data, exit the current mode or
cancel an action.
A numeric key illuminates if its
corresponding zone is open.
Partition 1
Partition 2
1686EQ02.fm Page 1 Friday, March 21, 2003 10:48 AM
To Next Page
Need help?
General
