Press and hold one of the key combinations
listed below for 2 seconds to activate a
panic alarm.
When the [
MEM] key is illuminated, an alarm
has occurred within your system. Press the
[
MEM] key to view the breached zone(s).
The breached zone’s corresponding key will
be illuminated.
When the [
TBL] key is illuminated, press it to view the Trouble Display ([TBL] key flashes).
Each key that is illuminated represents a separate trouble condition as shown below:
When the [
BYP] key is illuminated, there are
bypassed zones currently in your system.
Method 1:
1. Press the [
BYP] key.
2. Enter your [
ACCESS CODE].
3. Press the keys corresponding to the
zones you wish to bypass, or press
[
BYP] to recall the previously
bypassed zones.
4. Press [
ENTER].
Method 2:
1. Press and hold the [
BYP]
†
key for 3
seconds.
2. Go to step 3 in method 1.
Press and hold the numeric key
corresponding to the zone for 3 seconds to
enable or disable chiming for that zone*.
Press and hold the [
CLEAR] key for 3
seconds to enable or disable keypad
muting*.
*A confirmation beep (BEEP-BEEP-BEEP-BEEP-
B
EEP) signifies that the feature has been enabled,
and a rejection beep (B
EEEEEEEEEEEEEP) sounds
when the feature is disabled.
PANIC ALARMS
†
Panic Alarm
Type
Key Combinations
Police
Medical
Fire
Press and hold [1] & [3]
Press and hold [4] & [6]
Press and hold [7] & [9]
ALARM MEMORY DISPLAY
TROUBLE DISPLAY
[1] Low/No battery [8] Clock loss (press [8] to reprogram HH:MM)
[2] Wireless transmitter low
battery
[9] Tamper/Zone wiring failure (press [9] to
view the zone)
[3] Power failure [10] Telephone line monitoring failure
[4] Bell/PGM2 disconnected [
STAY] Fire zone trouble
[5] Bell current failure [
BYP] Module loss
[6] Auxiliary current failure [
MEM] Wireless transmitter supervision loss
[7] Communication failure [
FORCE] Keypad fault
BYPASS PROGRAMMING CHIME PROGRAMMING
†
Must be enabled by your installer.
© 2003 Paradox Security Systems. Spectra is a registered trademark of Paradox Security Systems.
1686EQ02.fm Page 2 Friday, March 21, 2003 10:48 AM
To Previous Page
Loading...
Need help?
General
