REM2 Feedback 3
8 EVOHD User Manual
REM2 Feedback 3
If your system includes the Wireless Zone Expansion module (RTX3), it will be able to support the Two-Way
Remote Control (MG-REM2). This remote allows you to change the status of the system, and it also provides
visual and auditory feedback.
NOTE: To see correct indications with REM 2 you must press the “i “ in the middle of the remote. This will show
the correct status.
3.1 Other Indicators
Table 1: Full/Force Arming Indicators
Action LED Sequence Auditory Sequence
Disarming Green on
TWO BEEPS
Exit delay Red / green slow flash
CONFIRMATION BEEP
Arming / Entry Delay Red on
CONFIRMATION BEEP
Alarm Red fast flash
ALARM BEEP
Table 2: Stay Arming Indicators
Action LED Sequence Auditory Sequence
Disarming Green on
TWO BEEPS
Exit delay Yellow / green slow flash
CONFIRMATION BEEP
Arming / Entry Delay Yellow on
CONFIRMATION BEEP
Alarm Red fast flash
ALARM BEEP
Table 3: Other Indicators
Action LED Sequence Auditory Sequence
PGM on/off Yellow on
CONFIRMATION BEEP
To Next Page
Loading...
