QUICK SET UP GUIDE
PARADOX SP5500 ALARM SYSTEMS
Step 1: Intial Setup
1. Locate the Alarm panel (this will be located in a cupboard/WIR).
2. Open the panel and connect the battery, there will be a black and red lead
loose, connect the black cable to black port on battery and red cable to red
port.
3. Remove any booklets left in the panel and close door.
4. Turn on the power point beside the alarm panel and proceed to the Keypad
at the entry of the home.
5. On the keypad the TBL button should now be illuminated RED.
Step 2: Setting the Date & Time
1. Press the TBL button (it will start to flash and the number 8 button will
illuminate)
2. Press the number 8 button. (ARM & TBL will flash in unison)
3. Enter the time as HH:MM.
4. Press 1 for 24-hour clock (SLEEP & TBL will flash in unison)
5. Enter the year as YYYY (Stay & TBL will flash in unison)
6. Enter the month as MM (OFF & TBL will flash in unison)
7. Enter the day as DD (All indicators will stop flashing except the TBL
button)
8. Press the CLEAR button to exit (TBL will stop flashing)
Step 3: Changing the Master Pin Code
1. Press the PWR +1234 (PWR & 1 will flash in unison)
2. Press 01 (ARM will flash)
3. Enter your new 4 digit PIN (SLEEP will flash)
4. Re-Enter 4 digit PIN (STAY will flash)
5. Press the ENTER button (PWR and 2 will flash in unison)
6. Press the CLEAR button to exit.
Step 4: Arming & Disarming of your system
1. Leaving the house – Enter your 4 digit PIN Code to arm alarm.
2. When you return home – Enter your 4 digit PIN code to disarm alarm.
To Next Page
Need help?
General
