Should you require any further information or
assistance, please contact our office on 1300 928 241
*****MONITORING*****
We offer 24/7 back to base monitoring; if you are interested in having your home
monitored, call our office where we can offer you a very competitive rate.
FAULT FINDING
In the event of a trouble appearing on your keypad, Press the [TBL] button on
your Keypad to view the trouble. Refer to the list below.
PWR Flashing – this error means that you need to replace the battery located
in the alarm panel box.
1. Wireless Zone – Low Battery (need to replace the battery on the wireless
sensor)
2. Power Trouble (check that the power supply beside alarm panel is plugged
in. This error will also arise when power is lost at the premises, but will
clear upon restoral of power)
3. Bell Trouble
4. Communication Trouble (if home is monitored, call your monitoring
provider to ensure communication has been restored)
5. Tamper & Zone Wiring Failure
6. Module Tamper Trouble
7. Fire Loop Trouble
8. Timer Loss
(follow step 2 on front page to reset time and date )
9. Wireless Zone Supervisor Failure
10. Module Supervision loss
16. Keypad Fault
17. Upgrade panel to V3.2 or higher
SLEEP. Keypad Fault
To Previous Page
Loading...
Need help?
General
