—
11
—
2. Battery Installation and Startup
The battery installation steps are as follows:
Note:
1
Please use a single 18650 rechargeable lithium-ion battery rated 3.7V voltage.
2
Do not expose the battery pack to high temperature or to a naked flame.
3
Do not put the device into water when the battery cover is open;
4
Do not expose disassemble the device without authorization;
5
Do not pierce the device with sharp objects;
6
Battery should be kept out of reach of children, and the positive and negative terminals of the battery
should be installed correctly;
7
Whilst charging the battery do not leave the battery unattended.
8
When using the battery at cold(low) temperatures, the battery capacity decreases, this is normal and
not a defect.
9
Do not use the battery if it has been damaged in any way.
10
After charging is complete do not leave the battery on charge connected to the network.
Please act responsibly and recycle or dispose of all used batteries according to the law.
(1) Unscrew the battery cap counterclockwise
and remove the battery
(2) Remove the insulating tape.
(3) Insert the battery, ensuring that the positive
(+) side goes in first and tighten the battery
cap clockwise.
(4) To turn on the device, press and hold the power
button for about 3 seconds. (When the power
light illuminates and the PARD Logo appears on
the screen, the device is ready for use.
To Next Page
Loading...
