Pard Predator Series - Page 23

—
19
—
2. Zeroing Adjustment
Zeroing adjustment refers to aligning the thermal imaging reticle with the optical reticle, ensuring that
the aiming point's position at a specific distance matches between the two.
●
toggle [Key 5] to move the cursor to the zeroing adjustment setting option. Press [Key 3] to enter the
sub-menu interface.
●
toggle [Key 2]/[Key 5] to select a set from five data sets(A-E), press [Key 3] to enter it.
●
press [Key 3] to enter the Pre-zeroing option.
●
move the X/Y axis by toggling [Key 2]/[Key 5] to adjust the red reticle to coincide with optical reticle,
press [Key 3] to switch the X/Y coordinates, then toggle [Key 4] to save and return.
●
toggle [Key 5] to enter the Zeroing adjustment option.
●
adjust the value of X/Y to move the yellow cross to the optical reticle, then toggle [Key 4] to return
and save.
Note: After each installation of the Predator, you can double-toggle [Key 4] to confirm whether the red
reticle aligns with the optical reticle. The red reticle will automatically vanish after three seconds.