Pari COMPACT2 - Troubleshooting; Technical Data; Compressor

5 TROUBLESHOOTING
The compressor must not be repaired except by the Technical
Service of PARIGmbH or a service center expressly
authorised to do so by PARIGmbH. If the compressor is
opened or manipulated by anyone else, all claims under the
warranty shall be void. In these cases, PARIGmbH will accept
no liability.
Fault Possible cause Remedy
The
compressor
does not start
up.
The power plug is
not plugged into the
mains socket
properly.
Check whether the power
plug is plugged into the
socket correctly.
The supply voltage is
not suitable for
running the
compressor.
Check whether the local
supply voltage matches the
voltage data marked on the
compressor identification
label.
No aerosol is
coming out of
the nebuliser.
The nebuliser nozzle
insert is blocked.
Clean the nebuliser.
The connection
tubing is not
connected properly.
Check that the tubing
connectors are connected
firmly to the compressor and
the nebuliser.
The connection
tubing is leaking.
Replace the connection
tubing.
6 TECHNICAL DATA
6.1 Compressor
General compressor data
Supply voltage[V]
Mains frequency[Hz]
Power consumption[A]
see label on confirmation of
purchase
– 33 –