8
Connector C1
6 Installation
Instruction book, IQAN- XT2
6Installation
Connector C1
Unshaded positions are Junior Power Timer pins. Shaded positions are Micro Timer II pins. See above for wire, seal, pin
number and crimping tool information. The IQAN tool kit is found in the ’IQAN accessories’ datasheet.
Connector kit Parker no. 5031063
Housing Amp no. 1-963226-1
Casing Amp no. 0-965643-1
Plane sealing, 42 p in module connector
Pin types* Amp no. 963711-2 (MT) Amp no. 929929-1 (JPT)
Cables 0,75-1,0 mm² (MT) 1,5-2,5 mm² (JPT)
Seals Amp no. 963530-1 (MT) Amp no. 828905-1 (JPT)
Plugs (empty pos.) Amp no. 963531-1 (MT) Amp no. 828922 (JPT)
IQAN crimping
tool references
Blue handle, pos. B
use blue extraction tool
Red handle, pos. B
use yellow extraction tool
IQAN tool kit Parker no. 5031061
Pos Signal name Pos Signal name Pos Signal name
1 ADDR-H 15 -BAT 29 -BAT2
2 DOUT-A 16 CAN-H 30 CAN-L
3 DOUT-B 17 COUT-A 31 COUT-A
4 DOUT-C 18 CRET-A+ 32 CRET-A-
5 DOUT-D 19 COUT-B 33 COUT-B
6 DOUT-E 20 CRET-B+ 34 CRET-B-
7 DOUT-F 21 VIN-A/EGAS-RET 35 VIN-F
8 EGAS+ 22 VIN-B 36 VIN-G
9 EGAS- 23 VIN-C 37 VIN-H/FIN-A
10 +VREF-EGAS 24 VIN-D 38 VIN-I/FIN-B
11 -VREF-EGAS 25 VIN-E 39 VIN-J/FIN-C
12 +VREF 26 CAN2-H 40 CAN2-L
13 -VREF 27 CAN-H 41 CAN-L
14 ADDR-L 28 +BAT
(+12 V, +24 V)
42 +BAT2
(+12 V,+24 V)
To Next Page
Loading...