iv) MPXE REAR JUNCTION BOX
1. Isolate the dryer electrically.
2. Make connections as shown below:-
If a DPE or drain connection is not used, leave the gland blanked off.
3. Connect at DPE’s in accordance with DPE Installation Manual supplied.
4. Connect at Drain Alarm connection in accordance with Condensate Drain Installation Manual supplied.
5. Re-apply power to the dryer.
18
To temperature
sensor
From controller
CONNECTION FROM BOTTOM OF
TERMINALS
1. Ready Made
2. Ready Made
3. Ready Made
4. Ready Made
5. Ready Made
6. Ready Made
7. WS Drain supply
8. AO Drain supply
9. AA Drain supply
10. Ready Made
11. Unused
12. Unused
13. Ready Made
14 Ready Made
CONNECTION FROM TOP OF
TERMINALS
1. Ready Made
2. Ready Made
3. DPE 1 Feedback (AO)
4. DPE 2 Feedback (AA)
5. DPE 3 Feedback (AR)
6. Unused
7. DPE 1 supply (AO)
8. DPE 2 supply (AA)
9. DPE 3 supply (AR)
10. WS Drain Feedback
11. AO Drain Feedback
12. AA Drain Feedback
13. ABV 24VAC
14 ABV Neutral
To Next Page
Loading...
