Parker PPPW2900 - Maintenance

24
25
TRANSPORT
Transport with the fuel switch in the off position. Ensure the engine is cooled so as
toavoidtheriskofburnsorre.
CAUTION:
Do not tilt the engine to avoid spilling fuel. Spilled fuel or fuel vapour may ignite.
STORAGE
If the engine is not to be used for a long period of time ensure it is stored correctly.
Make sure the storage area is dry and free of dust.
PREPARE FOR STORAGE
Disconnect the spark plug. Put a spoonful of fresh engine oil into the cylinder and rotate
the engine to distribute the oil evenly. Replace the spark plug.
Pull the starting rope until you feel resistance and then keep pulling so as to align the
arrow of the starting sleeve with the hole of the starter: This will close both the inlet and
outlet valves to help prevent the engine rusting inside.
Cover the engine to keep it free of dust.
REMOVAL FROM STORAGE
Before re-using, service the engine in accordance with the instructions in the
following table.
1 Unscrew the drain plug and drain out the fuel in the carburettor:
2 Turnofftheengineswitchrst,disconnectthedepositcupandemptyit.
NOTE:
Do not dump oil containers or discarded engine oil into the ground. For environmental protection take
discarded engine oil in a closed container to a recycling station.
WARNING:
Fuelisextremelyammableandexplosiveundercertainconditions.Keepcigarettes,nakedamesand
sparks away from operating site.
STORAGE TIME SERVICE ITEM
Within one month No service needed
One - Two months Drain out original fuel of the fuel tank and refuel
Two months - One year
Drain out original fuel of the fuel tank and refuel
Drain out the fuel in the carburettor 1
Empty the deposit cup 2
Above One year
Drain out original fuel of the fuel tank and refuel
Drain out the fuel in the carburettor 1
Empty the deposit cup 2
Move the engine from the storage place, and start up
MAINTENANCE