12
13
OPERATION AND USE
WARNING: Theengineisnotlledwithoil.Itisnecessarytoll
the unit before starting the engine. The engine will not
produceasparkunlesssufcientoilisinside.
CAUTION: Do not run the engine with high or low oil level as this can
cause engine damage.
CAUTION: Only use unleaded gasoline.
CAUTION: Avoid damaging your hose by ensuring it does not touch
the hot exhaust during and after use.
CAUTION: Avoid damaging your pump by ensuring the water supply
is clean and free of any foreign objects.
CAUTION: Inlet water temperature must not exceed 40°C and 1Mpa
CAUTION: Never let the appliance operate for more than 2 minutes
with the spray gun in the closed position.
CAUTION: Never operate the pressure washer with repeated and rapid on
and off movements of the trigger.
WATER SUPPLY FROM THE WATER MAIN
■ Connect a water supply hose (not supplied) to the water inlet
connection of the pressure washer.
■ Turn on the water supply and pull the trigger until water is continually
owingoutofthenozzle.
WATERSUPPLIERFROMACONTAINER*
■ Unscrew the coupling part for the water inlet.
■ Screwthesuctionhosewithlter(notincluded)ontothewaterconnection
of the unit.
■ Hangthelterinthecontainer.
■ Vent the unit before operation.
■ Unscrew the high pressure line at the high pressure outlet of the unit.
■ Switch on the unit and let it run until water is free of bubbles at the high
pressure outlet.
■ Switch off the unit and screw on the high pressure hose again.
Failure to comply with the above conditions causes serious mechanical
damage to the pump and the loss of the warranty cover.
Pull the trigger to eliminate trapped
air and wait for a steady ow of
water to emerge from the spray
nozzle.
NOTE:
Inordertoassisttherststartupitis
recommended to press the trigger
during the pulling of the starter
handle.
To prevent accidental operation the
triggeristtedwithalockingfacility.
FIG. 16
FIG. 17