Parker PPPW2900 - Page 7

10
11
CONNECTING THE FILTER
ONTO THE SUCTION HOSE
(FIG. 8):
To prevent any dirt from being
sucked into the pump of the
machinealtermustbeused.
Locatethelterbypushingit
inside the hose connector.
FITTING THE HOSE
CONNECTOR ONTO THE
WATER INLET (FIG. 9):
Screw the hose connector C
onto the thread of the water
inlet connector, this will allow
a garden hose to be quickly
connected/disconnected.
ENGINE OIL (FIG. 10 & 11):
WARNING:
The engine is not provided with oil. It is necessary to ll
the unit before starting the engine. The engine has two oil
ll points at the front and back of the engine. Remove the
desiredcapandllwiththeengineoilspeciedtotheupper
level mark.
Replacetheoilllercap.
HIGH PRESSURE
CONNECTION
(Figs. 12.-17):
Connect the high pressure
hose D to the unit’s high
pressure outlet.
INSERTING A NOZZLE
(Fig 14):
To insert a nozzle, pull back
the locking collar at the end
of the lance, insert nozzle
and release the collar. This
will lock the nozzle in place.
Ensure the nozzle is inserted
correctly. If notitcanyout
and injure personnel or
damage property.
FIG. 8 FIG. 9 FIG. 10 FIG. 11 FIG. 12 FIG. 13 FIG. 14 FIG. 15
Connect the high pressure
hose to the trigger E. Insert
the lance F into the trigger.
Press rmly against the
spring tension and twist
the coupling into the locked
position. Insert the required
nozzle by retracting the
coupling at the end of the
lance, ensure the nozzle is
inserted securely.
CONNECTING THE HOSE
(Fig 15):
Connect the hose to the
unit’s water inlet connector
(Max. 10 bar, max.
tempreture 40°C) and turn
the water on completely.
ASSEMBLY
C
D
E
F
WARNING:
Theengineisnotprovidedwithoil.Itisnecessarytolltheunitbeforestartingtheengine.