32
Do not work with the lawn-
mower without the collision
guard or lawn box. There is
a risk of injury.
Level gauge
.
the device is in operation.
Adjusting the Cut Height
(Fig. E)
Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
desired cut height setting.
in order to prevent to mower rolling
away.
The correct height is around 25 – 40 mm
for a decorative lawn and around
A higher cut height should be se-
Observe the noise protection and
local regulations.
Mulching kit
(Fig. F)
Inserting the mulching kit
if used.
ejection shaft.
4. Press the bottom of the mulching kit
into the ejection chute until the mulch-
ing kit locks into place.
Removing the mulching kit
ejection chute.
Side grass ejection
(Fig. G)
When using the side ejection chute, the cut
grass falls sideways onto the lawn.
Do not use the side grass ejection
when mulching.
This prevents the clippings from
accumulating in the ejection chute.
3. Lift the impact protection on the side
To Next Page
Loading...