35
blade - washer - blade bolt
Adjusting the Bowden cable
-
saligned and has too much play, you can
adjust it.
anticlock-
wise: The Bowden cable shortens.
clockwise:
Storage
Set the cutting height of 38 mm in
front of both vertical bearing posi-
tions, for safe positioning of the machine.
Vertical storage (Stow Function)
In this position, the connecting
caps do not have to engage
neatly in the mount on the lawn mower
housing.
4. Tilt the machine backwards Use illustra-
tion J as a comparison.
Alternatively, you can fold up
the mower even further when
stored vertically:
again.
-
5. Tilt the machine backwards Use illustra-
tion J as a comparison.
-
reach of children.
The machine cable
must not be jammed when you do this.
ng
bags as moisture could build up.
We will not be liable for damages caused
by our equipment where these are caused
by improper repair or the use of non-
original parts or by use other than for the
intended purpose.
Transport
Before transporting the device,
switch it off, pull out the mains plug
and wait for the blade to come to
a stop. There is a risk of personal injury.
the device.
To Next Page
Loading...