EasyManuals Logo

Parkside Performance PSBSAP 20-Li A1 User Manual

Parkside Performance PSBSAP 20-Li A1
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
PSBSAP 20-Li A1
8
GB
IE
NI
To avoid potential risks, damaged
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable
for indoor use only.
WARNING!
To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person.
ATTENTION!
This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP20 A3.
A current list of battery compatibility can be
found at www.Lidl.de/Akku.
Before use
Charging the battery pack
(seefig.A)
CAUTION!
Always unplug the tool before you remove
the battery pack from or connect the battery
pack to the charger.
NOTE
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
Connect the battery pack! to the high-speed
charger 0 (see fig. A).
Insert the power plug into the socket. The red
charge control LED % lights up red.
The green charge control LED + indicates
that the charging process is complete and the
battery pack! is ready for use.
ATTENTION!
If the red charge control LED% flashes,
this means that the battery pack! has
overheated and cannot be charged.
If the red and green charge control LEDs%/
o both flash, this means that the battery
pack! is defective.
Push the battery pack! back into the tool.
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
IB_329697_PSBSAP20-LiA1_LB6.indb 8 26.08.20 17:08

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Parkside Performance PSBSAP 20-Li A1 and is the answer not in the manual?

Parkside Performance PSBSAP 20-Li A1 Specifications

General IconGeneral
Voltage20 V
Battery TypeLi-Ion
Max Torque60 Nm
Chuck Size13 mm
Speed Settings2
No-load Speed0-500 / 0-2000 rpm
Chuck Capacity1.5 - 13 mm
Drilling Diameter (Steel)13 mm
Torque Settings21 + 1

Related product manuals