Why does the Parkside 102787 Saw motor start up slowly?
If the motor starts up slowly and does not reach operating speed on your Parkside Saw, the voltage might be too low, the coils could be damaged, or the capacitor might be burnt. Contact the utility provider to check the voltage. Arrange for a specialist to inspect the motor and replace the capacitor.
What to do if my Parkside Saw motor does not work?
If the motor isn't working, the issue might stem from a defect in the motor, cable, or plug, or blown fuses. It's recommended to have a specialist inspect the machine. Never attempt to repair the motor yourself due to the danger involved. Also, check the fuses and replace them if needed.
Why is the saw cut rough or wavy with my Parkside 102787?
If the saw cut is rough or wavy when using your Parkside Saw, it could be due to a dull saw blade or a tooth shape that isn't appropriate for the material thickness. To fix this, try resharpening the saw blade, or using a suitable saw blade designed for the material you're cutting.
Why doesn't my Parkside 102787 motor reach its full power?
If your Parkside Saw motor isn't reaching its full power, it might be because the circuits in your network are overloaded with other equipment or motors. To resolve this, avoid using other equipment or motors on the same circuit while operating the saw.
Why does the Parkside 102787 Saw motor overheat easily?
To prevent the motor from overheating, avoid overloading it during cutting tasks. Additionally, make sure to regularly remove dust from the motor to ensure it cools properly.
What causes reduced cutting power when sawing with my Parkside 102787 Saw?
Reduced cutting power could be due to a saw blade that is too small or has been ground down too much. Readjust the end stop of the saw unit.
Why does the motor start up slowly and not reach operating speed on my Parkside Saw?
If the motor starts slowly and doesn't reach operating speed, it could be due to low voltage, damaged coils, or a burnt capacitor. Contact the utility provider to check the voltage. Arrange for a specialist to inspect the motor and replace the capacitor if necessary.
How to fix a rough or wavy saw cut with my Parkside 102787?
A rough or wavy saw cut can occur if the saw blade is dull or the tooth shape isn't right for the material thickness. Resharpen the saw blade, or use a more suitable saw blade.
What to do if the workpiece pulls away and/or splinters when using my Parkside 102787 Saw?
If the workpiece pulls away or splinters, it might be because of excessive cutting pressure or an unsuitable saw blade. Insert a suitable saw blade.
Why does my Parkside 102787 Saw motor make excessive noise?
Excessive noise from the motor could indicate damaged coils or a defective motor. Arrange for a specialist to inspect the motor.
General| Type | Circular Saw |
|---|---|
| Power | 1200 W |
| No-load speed | 5500 RPM |
| Cutting depth (at 90°) | 65 mm |
| Weight | 3.8 kg |
| Power Source | Corded Electric |
To Next Page
