To Next PageTo Next PageWhy does my Parkside 290768 motor overheat easily?
Your Parkside Saw motor may overheat because it is being overloaded or not sufficiently cooled. To resolve this, avoid overloading the motor during cutting. Additionally, remove any dust from the motor to ensure it cools effectively.
What to do if my Parkside 290768 motor does not work?
If the motor of your Parkside Saw doesn't work, the cause may be a defective motor, cable, or plug, or burnt fuses. Check the fuses and replace them if necessary. It is recommended to arrange for a specialist to inspect the machine. Never attempt to repair the motor yourself due to the danger.
Why doesn't my Parkside Saw motor reach its full power?
The motor in your Parkside Saw might not reach its full power because the circuits in the network are overloaded by other equipment like lamps or other motors. To fix this, avoid using other equipment or motors on the same circuit.
How to fix a rough or wavy saw cut with my Parkside 290768?
A rough or wavy saw cut from your Parkside Saw is likely due to a dull saw blade or a tooth shape that isn't appropriate for the material thickness. To correct this, resharpen the saw blade or use a suitable blade for the material you're cutting.
Why does my Parkside 290768 motor start slowly and not reach full speed?
If your Parkside Saw motor starts slowly and doesn't reach its operating speed, it could be due to low voltage, damaged coils, or a burnt capacitor. Contact the utility provider to check the voltage. It's also recommended to arrange for a specialist to inspect the motor and replace the capacitor.
What to do if the workpiece pulls away or splinters when using my Parkside 290768 Saw?
If the workpiece pulls away or splinters when using your Parkside Saw, it may be due to excessive cutting pressure or an unsuitable saw blade. Try inserting a suitable saw blade.
Why is my Parkside Saw motor making excessive noise?
If your Parkside Saw motor is making excessive noise, the cause might be damaged coils or a defective motor. It is recommended to arrange for a specialist to inspect the motor.
General| Brand | Parkside |
|---|---|
| Model | 290768 |
| Category | Saw |
| No-Load Speed | 5000 rpm |
| Voltage | 230 V |
| Mitre angle | 45° |
