What to do if my Parkside 298657 engine will not start?
If the Parkside Saw's engine won't start, there are several potential causes: * A blown mains fuse: Check and replace the mains fuse if necessary. * A defective extension cable: Replace the extension cord. * Faulty connections on the motor or switch: Have an electrical specialist repair the connections. * A faulty motor or switch: Have an electrical specialist repair the motor or switch.
Why does my Parkside 298657 Saw leave fire marks on the cutting surface?
Fire marks appearing on the cutting surface when using the Parkside Saw can be due to: * A blunt saw blade: Sharpen or change the saw blade. * Using the wrong saw blade: Change the saw blade to the correct one.
What to do if the Parkside 298657 Saw motor won't work, but the fuse is active?
If the Parkside Saw motor doesn't work but the fuse is active, it could be due to: * Insufficient cross section of the extension cable: Consult the 'Electrical connection' section. * Overload caused by a blunt saw blade: Change the saw blade.
Why is my Parkside 298657 Saw motor rotating in the wrong direction?
If the Parkside Saw motor rotates in the wrong direction, the possible causes are: * A faulty capacitor: Have an electrical specialist repair the capacitor. * Incorrect connection: Have a qualified electrician exchange the polarity of the outlet.
How to fix a Parkside 298657 when the blade dissolves after switching off the engine?
If the blade of your Parkside Saw dissolves after switching off the engine, it may be due to a slightly tightened fastening nut. To resolve this, tighten the right hand thread nut.
To Next Page
General