EasyManua.ls Logo

Parkside 377366 2110 - User Manual

Parkside 377366 2110
172 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Waschsauger / Carpet Cleaner / Aspirateur injecteur/
extracteur PWS 20 C2
Aspirateur injecteur/extracteur
Traduction des instructions d‘origine
Odkurzacz piorący
Tłumaczenie oryginalnej instrukcji obsługi
Tepovač
Preklad originálneho návodu na obsluhu
Lava-aspirador
Traducción del manual de instrucciones original
Waschsauger
Originalbetriebsanleitung
Mosó-szívó
Az originál használati utasítás fordítása
Natte zuiger
Vertaling van de originele gebruiksaanwijzing
Tepovač
Překlad originálního provozního návodu
Tekstilrenser
Oversættelse af den originale driftsvejledning
Lava-aspira
Traduzione delle istruzioni d’uso originali
Pralni sesalnik
Prevod originalnega navodila za uporabo
Carpet Cleaner
Translation of the original instructions
I A N 37 736 6 _ 2110

Table of Contents

Questions and Answers

  • S
    sabrina42Aug 11, 2025
    What to do if my Parkside Vacuum Cleaner has low suction?
    • K
      Krystal JacksonAug 11, 2025
      If your Parkside Vacuum Cleaner has low suction, it could be due to several reasons. First, check if the suction hose or nozzle is blocked and remove any obstructions. Ensure the air control on the handle is closed. Also, make sure the container is closed and not full; empty it if necessary. The filter might be full or clogged, so empty, clean, or replace it. Finally, check if the float in the filter basket can move freely; if not, release it. If the float is faulty, it should be repaired by Customer Care.
  • R
    rachelduranAug 18, 2025
    What to do if dust is blown out of my Parkside Vacuum Cleaner?
    • G
      Gary WardAug 18, 2025
      If dust or dirt is being blown out of your Parkside Vacuum Cleaner, it's likely that the filter is either missing or not correctly assembled. To resolve this, either install the missing filters or ensure that the existing filter is positioned correctly.
  • S
    Sydney GainesAug 27, 2025
    Why won't my Parkside 377366 2110 start?
    • L
      Lisa MurphyAug 27, 2025
      If your Parkside Vacuum Cleaner won't start, the issue could stem from a few potential causes. Begin by verifying that the mains voltage is present by checking the plug socket, cable, line, plug, and fuse. If any of these components are defective, have them repaired by an electrical specialist. A defective on/off switch may also be the culprit, which should be repaired through customer service. Other potential causes are worn carbon brushes or a defective motor, but the manual does not specify solutions for these.
  • A
    Alyssa RamirezSep 3, 2025
    What to do if the float doesn't switch off my Parkside 377366 2110?
    • H
      Heather DavenportSep 3, 2025
      If the float in the filter basket of your Parkside Vacuum Cleaner is not switching the appliance off, the float may not be moving freely. Release the float to ensure it can move. If the float is still faulty, it should be repaired by Customer Care.

Parkside 377366 2110 Specifications

General IconGeneral
BrandParkside
Model377366 2110
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals