20 GB
Align the connection screw
[] with the hole
in the connector
[5].
Hold the main handle
[1]. Turn the product
by 90º.
Use a cross-head screwdriver (not included)
to turn the connection screw
[] in a
clockwise direction until fully tightened.
Slightly press the dust port
[] onto the dust
extractor
[] until the dust extractor is firmly
connected to the dust port.
You can orient the dust port
[] in
different directions to suit different working
environments.
Removing the dust extractor
Turn the connection screw
[] in an anti-
clockwise direction until completely loose.
Remove the dust extractor
[] from the
product.
To Next Page
Loading...
