6
GB CY
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
also be used for a preliminary exposure
assessment.
Warning:
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
as low as possible. An example of how
to reduce vibration exposure is limiting
the working hours. For this purpose all
parts of the operating cycle have to be
considered (for example, times when
the electric tool is switched off and
times when it is switched on but run-
ning without any load).
Attention! An up-to-date list
of battery compatibility can
be found at:
www.lidl.de/akku
following rechargeable batteries:
with the following chargers:
Safety instructions
Ensure that the safety instructions are ob-
served when operating the appliance.
Symbols and icons
Symbols on the appliance:
Carefully read these operating in-
structions.
Wear personal protective equip-
ment. Wear eye protection!
Wear hearing protection!
Wear a dust protection mask!
Drilling/screwing
Impact drilling
Electrical appliances must not be
disposed of with the domestic
waste.
be used when the keyless chuck is
attached.
Symbols in the manual
Warning symbols with in-
formation on damage and
injury prevention.
Hazard symbol with infor-
mation on the prevention of
personal injury caused by
electric shock.
Instruction symbols with information
on preventing damage.
To Next Page
Loading...
Need help?
General