To Next PageTo Next PageWhy does my Parkside PBS 350 A1 leave burn marks on wood?
If burn marks appear on the wood during cutting with your Parkside Saw, this could be caused by a blunt or wrong saw blade. Try to change the saw blade or select a saw blade according to the operating instructions.
Why is my Parkside Saw cut rough or wavy?
If your Parkside Saw cut is rough or wavy, it could be due to a dull saw blade or a tooth shape that's not appropriate for the material thickness. Try resharpening the saw blade and/or using a suitable saw blade.
Why does my Parkside PBS 350 A1 Saw motor overheat easily?
If the Parkside Saw motor overheats easily, it could be due to overloading or insufficient cooling. Try to avoid overloading the motor while cutting. Also, remove any dust from the motor to ensure it cools properly.
Why does my Parkside PBS 350 A1 Saw motor not reach full power?
If your Parkside Saw's motor is not reaching its full power, it might be due to overloaded circuits. Try not using other equipment or motors on the same circuit.
How to prevent Parkside PBS 350 A1 motor from overheating?
To prevent the motor of your Parkside Saw from overheating, avoid overloading it during cutting tasks. Additionally, ensure optimal cooling by regularly removing dust from the motor.
Why does the Parkside PBS 350 A1 Saw motor start slowly and not reach full speed?
If the motor of your Parkside Saw starts up slowly and does not reach operating speed, it could be due to voltage being too low, damaged coils, or a burnt capacitor. Contact the utility provider to check the voltage. Arrange for inspection of the motor by a specialist. Arrange for replacement of the capacitor by a specialist.
Why does my Parkside PBS 350 A1 motor make excessive noise?
If the motor of your Parkside Saw makes excessive noise, it could be due to damaged coils or a defective motor. Arrange for inspection of the motor by a specialist.
Why is the saw blade not running straight on my Parkside PBS 350 A1?
If the saw blade of your Parkside Saw is not running straight, it could be because the guide has been wrongly set or the wrong saw blade is in use. Set the saw blade guide according to the operating instructions and select a saw blade according to the operating instructions.
How to troubleshoot a Parkside PBS 350 A1 when the motor does not work?
If the motor of your Parkside Saw does not work, it could be due to a defective motor, cable, or plug, burnt fuses, or an open housing cover. Have a specialist inspect the machine. Check the fuses and replace them if necessary. Ensure the housing cover is closed correctly.
Why does the workpiece pull away or splinter when using my Parkside PBS 350 A1 Saw?
If the workpiece pulls away or splinters when using your Parkside Saw, it may be due to excessive cutting pressure or an unsuitable saw blade. Try inserting a suitable saw blade.
Lists all items included in the package with the band saw.
Describes the specific purpose and application for which the band saw is designed.
Guide for assembling the saw table onto the band saw machine.
Instructions on how to properly tension the saw band for optimal operation.
Guide on adjusting the saw band alignment on the rollers for accurate cuts.
Details on adjusting the top guide pins for precise saw band alignment.
Instructions for adjusting the bottom guide pins for correct saw band guidance.
How to adjust the height of the top saw band guide relative to the workpiece.
Guide to set the saw table to a precise 90-degree angle for square cuts.
Advice on choosing saw bands and steps for replacing them.
Information on replacing the table insert and using the extraction nozzle.
Instructions for turning the machine on and off using the main switch.
Guide on how to use the parallel stop for straight cuts.
How to perform angled cuts by tilting the saw table.
Instructions for performing cuts along the length of the workpiece.
How to perform angled cuts using the adjusted saw table.
Techniques for cutting curves and radii without a guide.
General