EasyManuals Logo

Parkside PHD 100 C2 User Manual

Parkside PHD 100 C2
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
GB IE
Releasing the lever will switch
off the washer, but the pressure
within the system is retained.
D
Lock / unlock the switch-on lever
of the gun (10) by depressing
the locking button (17).
Lock the switch-on lever to prevent
the pressure washer from being in-
advertently / accidentally started.
Locked
Open
In case of leaks in the water
system, immediately switch
off the equipment at the on/
off switch (5) and disconnect
the mains cable (7) of the
equipment from the mains.
There is a risk of electric
shock. Start restoring the wa-
ter connections (see “Initial
Operation – Setup”).
If there is still air in the equipment,
please proceed as follows:
Bleed the supply hose:
1. Remove the quick connection for the
garden hose adapter on the water
connection (8) and open the water tap
until water with no bubbles emerges.
2. Close the water tap.
3. Connect the supply hose to the equip-
ment with the aid of the quick connec-
tion for the garden hose adapter (8).
4. Fully open the water tap.
Bleed the equipment:
5. Switch on the equipment at the on/off
switch (5) until the pressure has built
up.
6. Switch off the equipment at the on/off
switch (5).
7. Depress the start lever on the spray
gun (10) until the pressure is released.
8. Please repeat steps 5. to 7. several
times until there is no further air in the
equipment.
Interrupting operation
Release the lever of the gun (
A
10).
During prolonged work intervals turn
off the washer by its ON / OFF switch
(
A
5).
Ending operation
After working with cleaning agents,
run the equipment with clean water to
completely rinse the cleaning agent
from the pipes.
Release the lever of the gun (
A
10).
Turn off the pressure by its ON / OFF
switch (
A
5).
Turn off the water tap.
Disconnect the pressure washer from
the water mains.
Pull the lever of the gun (
A
10) to vent
the pressure existing within the system.
Disconnect the mains plug.
Using detergents
The washer was designed for operation
with a neutral detergent based on a bio-
logically decomposable anionic tenside.
Other detergents or chemical substances
could impair the safety of the washer and
damage it.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Parkside PHD 100 C2 and is the answer not in the manual?

Parkside PHD 100 C2 Specifications

General IconGeneral
BrandParkside
ModelPHD 100 C2
CategoryPressure Washer
LanguageEnglish

Related product manuals