EasyManuals Logo

Parkside PHD 100 C2 User Manual

Parkside PHD 100 C2
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
IEGB
E
Fixing the Wheels
The back wheels on the chassis (9) can be
-
er against undesired rolling away.
To do this push the two bolts (16) out-
wards and downwards.
The wheels are now no longer able to
turn.
 
two bolts (16) upwards.
F
Removing the Chassis
The pressure washer can also be used
without the chassis (9).
Press the release button (18) on the
front locking point. Hold the chassis (9)
securely in the front area and pull the
pressure washer upwards.
At the same time, tilt the pressure
washer slightly to the rear.
To reinstate, insert the device into the
rear area of the chassis (9). Push down
on the device down and press the re-
lease button (18) at the same time. The
device clicks into the chassis.
Cleaning and Mainte-
nance
Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.
Cleaning
Never direct the water jet
against the washer, nor clean

water. This could give rise to
the danger of electric shock
and damage the washer! .
Always keep the washer clean. Do
not use any detergents or solvents.
Always keep the ventilation slots clean
and free.
Only clean the pressure washer with a
soft brush or a slightly moist cloth.
In case a nozzle of the jet tube
(12/13) is clogged up, use the nozzle
cleaning pin (15) to remove the object
from the nozzle.
G
If necessary, take off the water con-


Maintenance
The pressure washer is maintenance free.
Ask our service centre to carry out
any work that is not described in
these instructions. Use only original
parts.
Storage
Drain all the water from the pressure
washer. Disconnect the unit from the
water supply. Press the On/Off switch
(
A
5) to turn on the pressure washer
for no longer than 1 minute until no
more water escapes from the high-
pressure connection (
A
5). Turn off the
unit.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Parkside PHD 100 C2 and is the answer not in the manual?

Parkside PHD 100 C2 Specifications

General IconGeneral
BrandParkside
ModelPHD 100 C2
CategoryPressure Washer
LanguageEnglish

Related product manuals