Parkside PHD 100 E2 - Troubleshooting; Common Problems and Solutions

2 8
GB
Trouble shooting
Problem Possible cause Remedy
Washer
is not
operating
ON / OFF switch (
A
5) is
turned off
Check ON / OFF switch.
Damaged power supply cable
(
A
8)
Check power supply cable (
A
8) for
damage. If necessary have the power
supply cable replaced by a qualied
electrician.
Mains fault
Check the electrical system for conformi-
ty with the data on the rating plate.
Washer
does not
transport
water
Air trapped in the pressure
washer
Switch on the equipment and pull the
lever of the gun (
A
10).
Bleed the equipment, see steps 5. - 8.
Washer
does not ge-
nerate any
pressure
Air trapped in the pressure
washer
Turn on the washer with high-pressure
hose until bubble-free water ows out of
the high-pressure connection (
A
3).
Drop in the water mains
pressure
Check the water mains.
Severe
pressure
uctuations
High-pressure nozzle (
A
13)
is dirty
Rinse the high-pressure nozzle (
A
13) with water. If necessary clean the
nozzle hole with a needle.
Clean the high-pressure nozzle (
A
13)
with the nozzle cleaning pin.