Parkside PHD 135 A1 User Manual

15
NI
IEGB
Trouble shooting
Problem Possible cause Remedy
Severe pres-
sure uctua-
tions
Standard Vario nozzle (11)
is soiled
Rinse the standard Vario nozzle (11)
with water. If required, clean the nozzle
bore hole with a needle (see chapter en-
titled cleaning).
Standard Vario nozzle (11)
is blocked
Remove the Standard Vario nozzle (11)
and ensure that the water can discharge
from the jet gun (9) unimpeded. In other
words, the device is working perfectly.
The turbo dirt blaster (22) do not nor-
mally get blocked.
Pressure
cleaner is not
operating
ON / OFF switch (3) is
turned off
Check ON / OFF switch (3)
Damaged power supply
cable
Switch off the equipment and disconnect
from the mains. Check power supply
cable for damage. If necessary have the
power supply cable replaced by a quali-
ed electrician.
Mains fault
Check the electrical system for conform-
ity with the data on the rating plate.
Pressure clean-
er does not
generate any
pressure
Air trapped in the pressure
cleaner
Switch on the equipment with the jet gun
and with no nozzle until bubble-free wa-
ter comes out.
Drop in the water mains
pressure
Check the water mains.
Leaks in the
water system
Connections not tted cor-
rectly
Switch off the equipment and disconnect
from the mains. Reconnect the equipment
to the water pipes (cf. “Initial Operation/
Set-Up”)
Water connection (7) leaks
Switch off the equipment and disconnect
from the mains. Replace the water con-
nection (7) inc. gasket (cf. “Spare Parts”)

Parkside PHD 135 A1 Specifications

General

Brand	Parkside
Model	PHD 135 A1
Category	Pressure Washer
Language	English