To Next PageTo Next PageWhy does my Parkside PRP 400 B1 switch off after a short period?
If your Parkside Water Pump switches off shortly after starting, it might be due to severe water pollution causing the motor contactor to disconnect the pump. To resolve this, pull out the mains plug and clean the pump. Alternatively, the water temperature might be too high, causing the motor contactor to break. Ensure the water temperature does not exceed 35°C.
What to do if my Parkside PRP 400 B1 Water Pump has no discharge?
There are several reasons why your Parkside Water Pump might have no discharge. The water level may be too low during commissioning, so try immersing the pump deeper. The thermal protection switch might have switched off; in this case, wait for the motor to cool down and switch back on, then pull out the mains plug and clean the suction foot/impeller. Also, the filter cover or filter could be blocked, so clean them.
Why is the flow rate insufficient in my Parkside PRP 400 B1 Water Pump?
Several factors can cause an insufficient flow rate in your Parkside Water Pump. The pump's performance might be reduced due to heavy dirt contamination or abrasive water impurities. In this case, pull out the mains plug, clean the pump, and replace consumable parts if necessary. The float switch might not be sinking properly, so check its position. Also, a blocked filter cover or filter can restrict the flow, so clean them.
What to do if my Parkside PRP 400 B1 Water Pump is operating but not pumping?
If your Parkside Water Pump is operating but not pumping, the pressure line might be closed. Open the shut-off valve on the distributor or any other taps or nozzles connected to the pump.
How to troubleshoot a Parkside PRP 400 B1 Water Pump that does not start?
If your Parkside Water Pump does not start, check if mains voltage is applied by inspecting the plug socket, cable, line, and plug. If necessary, have it repaired by an electrical specialist. Also, the float switch might not be switching; check its position.
General| Power | 400 W |
|---|---|
| Max Suction/Immersion Depth | 7 m |
| Max Particle Size | 5 mm |
| Cable Length | 10 m |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Hose Connection | 1" (25 mm) |
Defines the intended uses and applications for the rain barrel pump, focusing on garden irrigation.
Lists all the components and parts included in the product package.
Provides a general visual and functional understanding of the pump's main parts.
Explains the operational principles and features of the rain barrel pump.
Details the essential technical specifications and performance metrics of the pump.
Clarifies the meaning of various symbols used on the device and in the manual.
Outlines crucial safety guidelines for operating the pump safely.
Step-by-step guide for putting the pump together before initial use.
Instructions on placing the pump in water and ensuring proper setup.
Guidance on correctly connecting the pump to an electrical power source.
How to set the automatic on/off points for the float switch.
Manual operation for starting and stopping the pump.
Basic cleaning procedures for the pump after each use.
Steps to clean the pump's removable filter.
Procedure to flush the pump with water after use.
Guidelines on how to store the pump when not in use.
