48 GB/IE
b) Secure the workpiece. A workpiece securely held by a clamping
device or vice is much safer than one held in your hand.
c) Hold the power tool firmly. High reaction moments can occur for
brief periods while lightening and loosening screws.
d) Switch the power off immediately if the tool blocks while
in use. Be prepared for high reaction moments as these can cause
kickback.
e) While working on the appliance, transporting it or
storing it, always set the rotation direction switch to the
central position (lock position). This prevents the power tool
from starting up unintentionally.
Vibration and noise reduction
To reduce the impact of noise and vibration emission, limit the time of
operation, use low-vibration and low-noise operating modes as well as wear
personal protective equipment.
Take the following points into account to minimise the vibration and noise
exposure risks:
Only use the product as intended by its design and these instructions.
Ensure that the product is in good condition and well maintained.
Use correct accessory tools for the product and ensure they are in good
condition.
Keep tight grip on the handles / grip surface.
Maintain this product in accordance with these instructions and keep it
well lubricated (where appropriate).
To Next Page
Loading...
Need help?
General
