To Next PageTo Next PageWhat to do if my Parkside PWS 125 C3 doesn't start?
If your Parkside Grinder doesn't start, the issue might stem from a missing mains voltage or a tripped main circuit breaker. Check the socket, mains cable, and plug. If necessary, have a qualified electrician perform repairs. Also, inspect the main circuit breaker. Another potential cause is a defective on/off switch, which requires repair by Customer Care.
Why grinding disc does not rotate smoothly in Parkside PWS 125 C3 Grinder?
If the grinding disc of your Parkside Grinder does not rotate smoothly and you hear abnormal noises, the grinding disc nut may be loose. In this case, tighten the grinding disc nut. Another possible reason is that the grinding disc is defective, so you should replace it.
Why grinding disc does not rotate smoothly on my Parkside Grinder?
If the grinding disc of your Parkside Grinder does not rotate smoothly and you hear abnormal noises, first, ensure the grinding disc nut is tightened. If the issue persists, the grinding disc may be defective and needs to be replaced.
What to do if grinding tools do not move in Parkside Grinder?
If the grinding tools of your Parkside Grinder don't move even when the engine is running, it could be due to a loose grinding disc nut. Tighten the grinding disc nut. Alternatively, the drive might be blocked by the workpiece, remaining workpieces, or remaining grinding tools. Remove any blockages to resolve this.
Why does the engine slow down and stop on my Parkside Grinder?
If the engine of your Parkside Grinder slows down and stops, it may be overloaded by the workpiece. Reduce the pressure on the grinding tool. It may also be that the workpiece is unsuitable.
What to do if grinding tools do not move on my Parkside Grinder?
If the grinding tools on your Parkside Grinder aren't moving even though the engine is running, check if the grinding disc nut is loose and tighten it. Also, inspect for any blockages caused by the workpiece or grinding tools and remove them.
Why does the engine of my Parkside Grinder slow down and stop?
If your Parkside Grinder's engine slows down and stops, it might be overloaded by the workpiece. Try reducing the pressure on the grinding tool. The workpiece may also be unsuitable.
General| Power | 1250 W |
|---|---|
| Disc Diameter | 125 mm |
| No-load Speed | 11000 rpm |
| Rated Voltage | 230 V |
| Spindle Lock | Yes |
| Restart Protection | Yes |
| Spindle Thread | M14 |
