1 4
GB IE NI CY
wor
king area should
wear personal protective
equipment. Broken bits from
the piece being worked or
broken attach
ment tools can y
away and cause injuries
even
beyond the direct working
area.
• Keep the cord away
from the rotating attach-
ment tool. If you lose con-
trol of the device, the power
cord can become separated
or caught and your hand or
arm may be pulled into the
rotating attachment tool.
• Never put the electric
tool down before the at-
tachment tool has come
to a full stop. The rotating
attachment tool can come into
contact with the surface upon
which it is set, whereby you
could lose control of the elec-
tric tool.
• Never allow the elec-
tric tool to run while
you are carrying it. Your
clothing may accidentally
come into contact with the
rotating attachment tool and
get caught and the attach-
ment tool could drill into your
body.
• Clean the ventilation
slots of your electric tool
routinely. The motor air
pulls dust into the housing
and, should too much metallic
dust collect, could cause elec-
trical hazards.
• Never use the electric
tool near ammable
material. Sparks could igni-
te this material.
• Do not use attachment
tools which require li-
quid coolant. Using water
or another liquid coolant
could lead to electrical shock.
Additional safety
instructions
• Only use grinding discs whe-
re the indicated rotational
speed is at least as high as
what has been specied on
the name plate of the device.
• Carry out a visual inspection
of the grinding disc before use.
Do not use any dama
ged or
deformed grinding discs. Re-
place
any damaged or worn
grinding discs.
• Make sure that the sparks
produced by grinding do not
present a danger, e.g. reach
people or ignite ammable
substances.
•
Always wear safety goggles,
safety gloves,
respiratory pro-
tection and ear protection
when grinding, brushing and
cutting.
• Never keep the ngers bet-
ween the grinding disc and
spark protection or in close
proximity to the protective
hoods. There is a risk of crus-
hing.
• The rotating parts of the de-
vice cannot be covered due
to functional reasons. There-
fore, proceed cautiously and
hold the workpiece rmly in
order to avoid slipping which
To Next Page
Loading...
Need help?
General