GOLF VI
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the
authorisation of Parrot SA. Pictures for information only.
Using the pull-through cord,
thread a blue wire under the
steering wheel and towards the
the air conditioning control unit.
Feed the wire to the left into the
fuse box housing.
Attach a 1.5-mm lug and insert it
into one of the slots at the top of
the fuse box. (Using the
multimeter, check that the +12 v is
connected to the ignition.)
1
3
2
Route the 12volt ignition supply
to the adaptor loom which links
to the Parrot fused (orange)
ignition wire, Solder and heat
shrink. Note this wire should not
be linked to the vehicle stereo.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
