items far away. Don’t touch flywheel or other moving parts.
When starting and operating, don’t touch ignition coil, spark plug cap or other electric parts.
The procedure is as follows:
1. Remove the top cowling.
2. Remove the start-in-gear protection device cable.
1. Start-in-gear protection device cable
3. Demount three bolts and remove starter.
4. Insert the knot of the cable in the notch of flywheel rotor, and wind the cable around flywheel
several rounds in clockwise direction..
5. Pull the manual starter handle slowly until you feel resistance.
6. Give a strong pull to start the engine. Repeat if necessary.
SAFETY WHILE WORKING
To prevent the danger or accidents when performing maintenance and repair, and improve the work
efficiency, please obey the following safety procedures.
1. FIRE PREVENTION
Gasoline (petrol), lubricant and grease are highly flammable. While working, keep away from heat,
sparks and open flames.
2
To Next Page
Loading...
Need help?
General
