EasyManuals Logo

Parsun F50/60 BWL-D User Manual

Parsun F50/60 BWL-D
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
18
CAUTION
· When the engine is cold, it needs to be warmed up.
· If the engine does not start on the first try, repeat the procedure. If the engine fails to start after
4 or 5 tries:
BW Models: open the throttle a small amount (between 1/8 and 1/4), and try again.
FW models: open the neutral throttle lever on the remote control box, and try again.
NOTE:
Never turn the main switch to “START” (start) while the engine is running.
Do not keep the starter motor turning for more than 5 seconds. If the starter motor is turned
continuously for more than 5 seconds, the battery will be quickly discharged, thus making it
impossible to start the engine. The starter can also be damaged. If the engine will not start after
5 seconds of cranking, return the main switch to “ON” (on), wait 10 seconds, and then crank the
engine.
2.6 Warm up engine
1. After starting the engine, place the gear shift lever in neutral. For approximately the first 3 minutes
after starting, warm up the engine by operating at one fifth throttle or less. Otherwise, it will shorten
engine life.
NOTE:
If the choke knob is left pulled out after the engine starts, the engine will stall.
In the temperatures of -5 or less, leave the choke knob pulled out fully for approximately 30
seconds after starting.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Parsun F50/60 BWL-D and is the answer not in the manual?

Parsun F50/60 BWL-D Specifications

General IconGeneral
BrandParsun
ModelF50/60 BWL-D
CategoryEngine
LanguageEnglish

Related product manuals