WATER BOILING SAFETY
In the event that there is a shortage of water in the boiler or insufficient absorption
of heat from the system due to blocking of circulation, overheating may occur until the
water itself boils.
A manual reset thermostat blocks the pellet loading motor: the thermostat is reset
manually and must be done by pressing the buttons located on the back of the boiler
and covered by screw-on caps.
Info: The intervention of the technical assistance center for boiler overheating is not
covered by the warranty.
3.5 POSITIONING OF THE DEFLECTOR
In the thermostove there is a rectangular deflector (figure 13), this must be
positioned on the fins placed in the upper part of the chamber combustion
(side fins) (figure 14).
(figura 13)
(figura 14)
To Next Page