Pasmo S930 - Fault Code and Solutions

PASMO
FAULT CODE AND SOLUTIONS:
Code
Error
HH
High voltage error
JJ
High electric current
error
（Frozen cylinder）
Solution
Check the voltage, It is set to 243 and if the voltage goes avove,
machine goes into fault state to protect itself. Call Reseller.
Press off, take out air tube, press/run wash for 5 min, then press
Auto to start. If the machine still shows JJ error, you need to press
Off and wait 20 min for cylinder to defrost, then press wash .
Check cylinder to make sure mix is flowing into chamber.
E1
Hopper sensor error
Contact reseller to change sensor (Sensor 16)
E2
Evaporation tank
sensor error
Contact reseller to change sensor (Sensor 15)
E3
Evaporation
temperature sensor
error
Contact reseller to change sensor (Sensor 14)
E4
Wrong phase
E5
lack phase
E6
Heat exhaust error
E7
Cylinder lack of
mixture
Lo
Cylinder temperature
is too low
1d
Heat exhaust error
FC
The motor doesn't run
R-CB
Right micro-switch
error
For 3 phase machine, the fire wire is wrong,
Change the position of any two of them. Call Electrician
For 3 phase machine, Wires are not connected correctly. Call Electrician
Check the heat exhaust. (check the location, and if condensor needs
cleaning ) Turn off the power and let the machine rest for 30 minutes
Press off, take out air tube, press wash and run for 5 minutes, then press
Auto. Check the mix and make sure it is flowing into the cylinder.
Press off, take out air tube, press wash and run for 5 minutes. Set the
hardness lower then press Auto.
Check the heat exhaust for the machine (when this error comes on, the
machine will run, but if you don't resolve, the machine will show
eventually show E6 and stop working)
Turn off the power and unplug from the wall for 5 minutes (must take
out the plug, not only turn off the power switch). After 5 Minutes plug
in and set the hardness lower, the pres Autro. Contact supplier if this
does not resolve issue.
Check to see if the handle has reset to its location, after reset, restart
the machine. Contact supplier if this does not resolve issue.
L-CB
Left micro-switch
error
M-CB
Middle micro-switch
error
PASMO
PART
11
PASMO
PASMO OPERATION MANUAL
ＰＡＳＭＯ ＯＰＥＲＡＴＩＯＮ
17
PLEASE OPERATE THE MACHINE CORRECTLY