EasyManua.ls Logo

Pass X150 - Page 13

Pass X150
13 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 13
X150 SPECIFICATIONS
All figures obtained after 1 hour warmup, with regulated 120 VAC power line. See manual
notes about AC power line regulation.
Gain 30 dB
Freq. Response -0 dB at DC, -3 dB at 100 kHz
Power Output 150 watts maximum @ 1% THD, 1 kHz, 8 ohms
Distortion refer to accompanying distortion curve
Maximum Output Voltage plus, minus 50 volts
Maximum Output Current plus, minus 20 amps
Input Impedance 22 kohm balanced
Damping factor 250 ref 8 ohms nominal
Slew rate plus, minus 50 V/uS
Output Noise 300 uV unweighted 20-20 kHz
Random noise floor approximately 2 uV
Dynamic range 145 dB (random noise floor to peak output)
Balanced CMRR -85 dB @ 1 kHz (input common mode rejection ratio)
DC offset < 100 mv
Power Consumption 200 watts idle, 600 watts maximum
Temperature 20 degrees C. above ambient at idle
Dimensions 19 " W x 20" D x 6.5" H
Shipping Weight 70 lbs.
PASSPASS
Pass Labs
PO Box 12878
Reno NV 89510-2878
www.passlabs.com
tel: (530) 367 3690
fax: (530) 367 2193

Related product manuals